* Selection of Hydraulic Components such as Couplings,
Adapters, Flanges...etc & selection of Bulk Hoses, Bulk Tubes based on the
functional requirements (PST)
* Routing Hydraulics lines using FLD (Fluid Lines Design)
* SWVL analysis which used for Hose length validation as
well as Hose Behavior in the articulating areas.
* Creo Mechanism to make sure there is sufficient clearance
with the other components in the articulating area like Boom, Stick &
Bucket cylinder & lines clearance with Boom, Stick when they were at Max
position.
* Hydraulic Schematic Drawings & very good in Hydraulic Schematic reading.